Question
What kind of supported Drone?
How do we setting for flight each Drone？
Answer/CauseThe following models are currently supported.（As of August 2026,）
Fully supported (PPK and GCP annotation)
DJI Phantom 4 RTK
DJI Mavic 3 Enterprise
DJI Matrice 300 RTK / Matrice 350 RTK with Zenmuse P1
DJI Matrice 4D
DJI Matrice 4E
DJI Matrice 400 with Zenmuse P1
ACSL Explorer1 with SkySync camera
Partially supported (GCP annotation only; PPK not supported)
DJI Inspire 2 with SkySync or FC6520 camera
ACSL SOTEN with CX-GB100 camera
DJI PHANTOM 4 RTK
Recommend flight setting
| Setting | Set to |
| Height | 100m or less |
| Speed | 2.9m/s (Max speed allowable) |
| Shooting Mode | Distance Shooting |
| Finish | Return to home |
| Altitude Optimization | Enabled |
| Relative Height | 0m |
| Camera Settings | Set to |
| Photo Ratio | 3:2 |
| White Balance | Set to the conditions of the day |
| Gimbal Angle | -90 |
| Shutter Priority | Enabled / 1000 |
| Distortion Correction | Disabled |
| Advanced Settings | Set to |
| Overlapping Rate (Side/Over) | 75/75 |
| Margin | Extend one lane beyond the measurement target area |
DJI Mavic 3 Enterprise
Recommend flight setting
| Setting | Set to |
| Camera | DJI Mavic3E WIDE |
| Terrain Follow | Disabled |
| Smart Oblique | - |
| ASL/ALT | ALT |
| Flight Route Altitude | 100m or less |
| Takeoff Speed | 10m/s |
| Speed | 11.2m/s (Max speed allowable) |
| Elevation Optimization | Enabled |
| Upon Completion | Return To Home |
| Advanced Settings | Set to (Mavic3E) |
| Overlap Rate (Side/Front) | 80/80 |
| Margin | Extend one lane beyond the measurement target area |
| Photo Mode | Distance Interval Shot |
| Camera Settings | Set to (Mavic3E) |
| Camera Mode | Shutter Priority |
| Shutter | 1/1000 |
| Dewarping | Disabled |
DJI Matrice 300 RTK
Recommend flight setting
| Setting | Set to (M300RTK) |
| Camera | Zenmuse P1 35mm |
| Terrain Follow | Disabled |
| Smart Oblique | Disabled |
| ASL/ALT | ALT |
| Flight Route Altitude | 150m or less |
| Takeoff Speed | 10m.s |
| Speed | 10.9m/s (Max speed allowable) |
| Elevation Optimization | Enabled |
| Upon Completion | Return To Home |
| Advanced Settings | Set to (M300RTK) |
| Overlap Rate (Side/Front) | 75/75 |
| Margin | Extend one lane beyond the measurement target area |
| Photo Mode | Distance Interval Shot |
| Camera Settings | Set to (M300RTK) |
| Camera Mode | Shutter Priority |
| Shutter | 1/1000 |
| Dewarping | Disabled |
Comments
0 comments
Article is closed for comments.